内蒙古快3

Do soluble salts affect paint bonding fiberglass carbon fiber hulls?

Share this:
Q:

Do soluble salts have any effect on paint bonding on fiberglass or carbon fiber hulls?

A:

The short answer to this question is yes。

The presence of soluble salts, particularly sulfates and chlorides, at the paint/hull interface can have detrimental effects on the integrity of the coating system. These salts promote destructive behaviors such as osmotic blistering.

Osmotic blistering, as its name suggests, is blistering by way of a process known as osmosis. Osmosis is the movement of a solvent through a semipermeable membrane from a less concentrated solution to a more concentrated one. The process continues until the concentrations of solute on each side of the membrane are equal.

Figure 1. Process of osmosis.

Figure 1. Process of osmosis. (Source: By Rlawson at English Wikibooks, CC BY-SA 3.0)

To simplify, what this means is that water (the solvent) will continue to move through the paint layer (semipermeable membrane) until the concentration of dissolved salts (solute) at the paint/hull interface is equal to the concentration of dissolved salts on the painted surface.

To better understand this definition and how it affects paint bonding内蒙古快3, let’s look at the stages of osmotic blistering below.

The paint (typically Gelcoat) acts as a semipermeable membrane. In other words, it allows only some components to pass through. In this case, the coating permits moisture, but not salts, to penetrate. The foundation for osmotic blistering is set when the coating is applied to a surface that is contaminated with soluble salts. (Related reading: Field Methods for Extraction and Analysis of Soluble Salts.)

When the fiberglass or carbon fiber hull sits in the water, the osmosis process begins. The water permeates through the semipermeable coating to mix with and dissolve the soluble salts at the paint/hull interface.

Because the concentration of dissolved salts at the paint/hull interface is higher than that at the paint surface, diffusion of water through the coating continues. This process persists until the soluble salt concentration on both sides of the membrane (paint surface) are equal.

The water gathered at the paint/hull interface eventually exerts an upward force on the coating that is greater than the adhesion and cohesion forces, causing blisters to form.

While osmotic blistering is difficult to control on fiberglass and carbon fiber hulls, . For example, applying a thick epoxy coating to the hull can create an extra separation layer between the Gelcoat and the water. This added protection helps to delay the onset of osmotic blistering.

Have a question? Ask us here.

View all questions from Krystal Nanan.

Share this:
Written by Krystal Nanan
Profile Picture of Krystal Nanan
Krystal is a civil engineer and project manager with an MSc in Construction Engineering and Management. Her experience includes the project management of major infrastructure projects, construction supervision, and the design of various infrastructure elements including roadway, pavement, traffic safety elements and drainage. Krystal is also a published author with the Transportation Research Board in Washington, D.C. Full Bio

Connect with us

Email Newsletter

Join thousands receiving the latest developments in corrosion technology industry.

report this ad
67娱乐系统 广西快3 股票配资 安徽快3 北京快3 甘肃快3 广西快3 67娱乐系统 江苏快3 极速快三